Project · Wineries and distilling

Winery Press Area MCC Replacement

Outdoor three-section motor control center with SmartWire-DT starters and ABB drives, built by PCA

Industry: A large California winery (crush and press area)

The challenge

The winery’s press area ran on an aging bucket-style MCC that was falling apart. It fed the presses’ free-run pumps, tube screw conveyors and press control panels, and its starters and drives were hardwired to the press area PLC. The winery needed a complete replacement that would stand up outdoors through crush season and give the PLC better information about every motor.

What we did

  • Designed and built a new outdoor MCC in a 3-door NEMA 3R enclosure, about 10 feet wide: a 1200 A main breaker and power distribution, plus branch breakers feeding the four press control panels and remote 480 V outlets.
  • Replaced the free-run pump soft starters with four 50 HP ABB ACS580 drives and fitted four ABB ACS380 drives for the tube screw conveyors, all on EtherNet/IP.
  • Used Eaton SmartWire-DT starters with smart trip units for every across-the-line motor, so the PLC sees current and diagnostics for each starter over EtherNet/IP instead of hardwired I/O.
  • Fitted side-mounted air conditioners on both ends of the enclosure to keep the drives cool through crush season.
  • Updated the press area PLC program and the plant’s Ignition HMI for network-based motor control, and rewired the master and four discharge-system E-stop circuits in the existing PLC panel.
  • Added drainer pushbutton stations with illuminated E-stops, press interlock relays and two sunlight-readable 21.5-inch touchscreen HMI stations overlooking the press area.
  • Produced the MCC layout and schematics and updated the existing PLC panel drawings, then supported installation and commissioning on site with our engineers and panel technicians.

The result

The press area now runs from one modern, air-conditioned MCC. Every starter and drive reports current, status and faults to the PLC and HMI, and operators have new local controls and overhead touchscreens for crush season.

Platforms and equipment

Allen-Bradley Logix PLC (existing press area controller), Ignition, Eaton SmartWire-DT, ABB ACS580 and ACS380 drives, EtherNet/IP, Allen-Bradley 800T

Related

Have a similar project?

Tell us what you are working on through the quote request form or the contact page. We design, build, program and start up control systems for plants across California.

Have a panel or project in mind?

Answer a few quick questions and a PCA engineer will get back to you within one business day.